Toyota LC76/79/HiLux

Heavy Duty Dynatrac™ Axle Upgrades for Toyota LC67, LC79 and HiLux Platforms

Dynatrac ProRock 44™ Front Axle Upgrade

The worst possible situation is a drivetrain failure that immobilizes the vehicle and makes it a target for hostility. Even armored vehicles can only withstand limited exposure time to serious threats. Dynatrac specializes in drivetrain durability solutions that are battle proven and cost effective to deploy. Dynatrac solutions will also reduce sustainment costs over the life of your defense program.

ProFloat XD60™ Rear Axle

  • The ProFloat XD60 rear axle provides weight capacity similar to a full-float axle while retaining a standard wheel flange and bolt pattern for a low-vis, high-capacity solution
  • The Dynatrac ProRock XD60 has a patented high ground clearance design which increases its ground clearance by 14mm, and reduces the obstacle impact area by almost 30%
  • 100% Made in the USA
  • Available with selectable locking and Trac-loc limited-slip differential options
  • The Dynatrac ProFloat XD60 is equipped with 95mm x 13mm wall axle tubes, virtually eliminating risk of axle housing bending
  • Uses high pinion, 258mm gears for additional strength and ground clearance advantages
  • Includes a highly impact resistant nodular differential cover
  • Equipped with high strength, 38mm, 35-spline, alloy steel, proprietary axle shafts
  • Readily accept factory Toyota rear brake assemblies and parking brake
  • Fully compatible with ABS and stability-control wheel sensors

ProRock XD60® Full-Float Rear Axle

  • The ProRock XD60 rear axle features much stronger full-floating wheel ends for additional weight capacity, up to 3,400 kg
  • The Dynatrac ProRock XD60 has a patented high ground clearance design which increases its ground clearance by 14mm, and reduces the frontal obstacle impact area by almost 30%
  • 100% Made in the USA
  • Available with selectable locking and Trac-loc limited-slip differential options
  • The Dynatrac ProRock XD60 is equipped with 95mm x 13mm wall axle tubes
  • Uses high pinion, 258mm gears for additional strength and ground clearance advantages
  • Includes a highly impact resistant nodular differential cover
  • Equipped with high strength, 38mm, 35-spline, alloy steel, full-floating, axle shafts
  • Readily accept factory Toyota rear brake assemblies and parking brake
  • Fully compatible with ABS and stability-control wheel sensors
  • Equipped with 8 on 6.5-inch BC wheel pattern and 9/16-18 wheel studs